Frigidaire Washer Error Code E31
Error Code E31 on Frigidaire washers indicates a communication breakdown between the water level pressure sensor and the electronic control board. It is important to note that this error is exclusive to models equipped with a digital display.
Troubleshooting Steps:
- Power Off: Start by unplugging the washer from the power source. This ensures safety during the inspection and troubleshooting process.
- Inspect Wire Harness Connections: Carefully examine the wire harness connections between the water level pressure sensor and the electronic control board. Over time, these connections may loosen or become compromised.
- Ensure Sound Wiring Connections: Confirm that the wiring connections are secure and free from damage. Any frayed wires or visible wear and tear should be addressed promptly.
- Replace Faulty Water Level Pressure Sensor: If the wiring connections are intact and the issue persists, the water level pressure sensor might be faulty. Consider replacing the sensor to restore proper communication with the control board.
Additional Notes:
- Digital Display Models Only: Error Code E31 is specific to Frigidaire washer models featuring a digital display. If your washer doesn’t have this feature, other error codes may apply to the issue.
- Professional Assistance: If troubleshooting on your own proves challenging or if you are uncertain about replacing the water level pressure sensor, seeking professional assistance is advisable. Knowledgeable technicians can efficiently diagnose and address the problem.
Conclusion: Frigidaire Washer Error Code E31 is a signal that demands attention to the communication link between the water level pressure sensor and the electronic control board. By following the outlined troubleshooting steps, you can potentially identify and resolve the issue. However, if uncertainties persist, reaching out to a qualified technician ensures a thorough diagnosis and effective resolution.