LG Washer Machine Error Code: OE

If your LG washer is displaying the OE error code, it means that there is a problem with the draining of the washer. This can be caused by a number of different reasons, such as a blocked drain hose, a clogged pump filter, a problem with the drain pump itself, or even a faulty pressure switch.

If your LG washer is displaying an OE error code, there are a few things you can do to try and fix the problem. First, check to make sure that the door is properly closed and latched. If it is, then try unplugging the washer for a minute or two before plugging it back in. If the error code persists, try and clear the drain hose of any kinks and clean out the pipe filter.

If this does not fix the issue, you may need to call a service technician to come and take a look at your washer.

What to do if an OE error code appears?

The LG washer error code OE is one of the most common codes to occur. If you get this code, it means that the washer has detected a water overflow condition. It indicates that there is water in the washer tub that needs to be drained. There are a number of things you can do to try and fix this, including unplugging the washing machine and checking the hoses for any kinks or blockages.

Another common cause of an OE error code is a clogged pipe filter, which should be cleaned out to avoid any blockages.

How to fix an OE error caused by a kinked drain hose?

If you’re seeing the OE error code on your LG washer, the first thing you should do is check the drain hose to make sure it’s not clogged. If it is, simply clear the obstruction and try running your washer again. If that doesn’t fix the problem, then check to see if the drain pump is working properly. If it isn’t, you’ll need to replace it.

If you see this error code, follow the steps below to fix it.

1. Unplug the washer from the power outlet
2. Remove the drain hose from the washer and place it in a bucket or sink
3. Restart the washer and let it run for a few minutes
4. Cancel the cycle and open the door to see if the water has been drained
5. If not, repeat the steps above until the water is drained
6. Once the water is drained, reattach the drain hose and plug the washer back in
7. Start a new cycle and see if the error code appears again. If you continue to see the OE error code, there may be a problem with your washer’s drainage system. In this case, it’s best to call a professional for help.

How to fix an OE error caused by a clogged drain pipe filter?

If your washer is displaying the OE error code, this indicates that there might be a problem with the drain pump. The drain pump helps to remove water from the washer tub during the washing cycle. It is important to check that the drain pump is not obstructed and that there is no debris caught in it.

The drain pipe filter should be cleaned of any debris on a monthly basis. If the drain pump is damaged, it will need to be replaced.

1. Turn the washer off and unplug it from the power supply
2. Open the drain pump filter cover by removing the small rectangular shaped cover at the bottom front of the machine
3. Detach the small hose and collect the water in a dish
4. Once drained, reattach the drain hose back into place
5. Remove the filter by turning the circular cover anticlockwise
6. Pull out the pump filter and empty the filter of any debris before hand washing it
7. Reinstall the pump filter and access cover

OE code persisting?

Finally, if the OE error code persists, you may need to reset the washer. To do this, unplug the washer from its power source and wait for 30 seconds before plugging it back in. Once the washer has reset, run a test cycle to see if the error code has cleared.