Call (323) 792-1970
Customer service:    323-792-1970
Schedule Appointment
Kitchenaid Oven Error Codes

Kitchenaid Oven Error Code F3/E1

Encountering the KitchenAid Oven Error Code F3/E1 can be disconcerting, but fear not, as we unravel the intricacies of this error to guide you through resolution. This error specifically points to a malfunction in the lower oven temperature sensor, a crucial component ensuring accurate temperature regulation for your culinary creations.

Understanding the Issue:

The F3/E1 error signifies that the lower oven temperature sensor is deemed defective. This sensor plays a pivotal role in maintaining the oven’s temperature, and a malfunction can lead to cooking discrepancies and hindered performance.

Initial Steps for Resolution:

  1. Power Disconnect:

    • Begin by disconnecting electrical power from the oven, ensuring safety during the troubleshooting process.

  2. Inspect and Reconnect Wires:

    • Thoroughly examine the lower oven temperature sensor for any loose wires.
    • Reconnect any wires that may have become dislodged during use.

  3. Evaluate Wire Harness:

    • Check the lower oven temperature sensor wire harness for any visible damage.
    • If damage is evident, replace the wire harness to ensure optimal functionality.

  4. Resistance Measurement:

    • Utilize a volt/ohm meter to measure the resistance of the lower oven temperature sensor.
    • At 70°F, the sensor should exhibit a resistance of 1080 ohms. Deviations from this value indicate a potential issue.

  5. Replacement of Temperature Sensor:

    • If the resistance falls outside the specified range, replacing the lower oven temperature sensor is recommended.

  6. Examine Electronic Oven Control Board:

    • If the sensor and wire harness prove to be in good condition, the next step is to inspect the electronic oven control board.
    • A malfunctioning control board may necessitate replacement to address the F3/E1 error comprehensively.

Navigating the F3/E1 error demands a systematic approach, ensuring each potential point of failure is thoroughly examined. Whether it’s re-establishing connections, replacing damaged components, or addressing electronic control board issues, a step-by-step assessment is key to restoring your KitchenAid oven to optimal functionality.

Schedule Appointment